Epson ES-300C Bollettino di assistenza prodotti - Pagina 7

Sfoglia online o scarica il pdf Bollettino di assistenza prodotti per Scanner Epson ES-300C. Epson ES-300C 25. Laser & non-impact printer error codes
Anche per Epson ES-300C: Bollettino di assistenza prodotti (19 pagine), Manuale (8 pagine), Manuale supplementare (15 pagine), Manuale (11 pagine), Bollettino di assistenza prodotti (20 pagine), Bollettino di assistenza prodotti (14 pagine), Bollettino di assistenza prodotti (13 pagine)

Epson ES-300C Bollettino di assistenza prodotti
EPL-7000 cont.
[E] REMOVE CARD
You may have inserted a font card or cartridge while the printer was on line or
while the FEED light was on. Data still remains in the printer's buffer.
[E] RESELECT TRAY
The optional lower paper cassette is not installed and the INPUT option is set
to OPT or AUTO.
[S] RESET
The printer is being reset to the previous settings in the macro specified with
LOAD MACRO option in SelecType Level 1.
[S] ROM Check
The printer is checking ROM.
[E] SAVE MEMORY OVERFLOW
If this message appears when you are trying to save a macro with the SAVE
MACRO option in SelecType Level 1, the printer does not have enough
memory to save any additional macros
[E] SERVICE REQ. CXXX
A controller error has been detected.
[E] SERVICE REQ. EOOXX
A print engine error has been detected.
XX= 03 Fusing Unit (low temp)
[E] SET FULL PRINT
This message may appear when you are trying to print graphics or a mix of
text and graphics.
[S] STANDBY MODE
When both CH P and CH S remain off for about thirty minutes, the printer
enters standby mode and this message appears.
[E] STARTUP ERROR
If this message appears when you turn on the printer, the power may have
been turned off while the printer was performing a save or reset operation.
04 Main Drive Motor
05 Ozone Fan motor
06 Polygon Mirror Drive
09 HSync Signal
PSB No: P-0077
Page: 6 of 11