Epson ES-300C 제품 지원 게시판 - 페이지 7

{카테고리_이름} Epson ES-300C에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ES-300C 25 페이지. Laser & non-impact printer error codes
Epson ES-300C에 대해서도 마찬가지입니다: 제품 지원 게시판 (19 페이지), 매뉴얼 (8 페이지), 보충 설명서 (15 페이지), 매뉴얼 (11 페이지), 제품 지원 게시판 (20 페이지), 제품 지원 게시판 (14 페이지), 제품 지원 게시판 (13 페이지)

EPL-7000 cont.

[E] REMOVE CARD

You may have inserted a font card or cartridge while the printer was on line or

while the FEED light was on. Data still remains in the printer's buffer.

[E] RESELECT TRAY

The optional lower paper cassette is not installed and the INPUT option is set

to OPT or AUTO.

[S] RESET

The printer is being reset to the previous settings in the macro specified with

LOAD MACRO option in SelecType Level 1.

[S] ROM Check

The printer is checking ROM.

[E] SAVE MEMORY OVERFLOW

If this message appears when you are trying to save a macro with the SAVE

MACRO option in SelecType Level 1, the printer does not have enough

memory to save any additional macros

[E] SERVICE REQ. CXXX

A controller error has been detected.

[E] SERVICE REQ. EOOXX

A print engine error has been detected.

XX= 03 Fusing Unit (low temp)

[E] SET FULL PRINT

This message may appear when you are trying to print graphics or a mix of

text and graphics.

[S] STANDBY MODE

When both CH P and CH S remain off for about thirty minutes, the printer

enters standby mode and this message appears.

[E] STARTUP ERROR

If this message appears when you turn on the printer, the power may have

been turned off while the printer was performing a save or reset operation.

04 Main Drive Motor

05 Ozone Fan motor

06 Polygon Mirror Drive

09 HSync Signal

PSB No: P-0077

Page: 6 of 11