Cisco UCS B200 M3 Nota di installazione e manutenzione - Pagina 16

Sfoglia online o scarica il pdf Nota di installazione e manutenzione per Server Cisco UCS B200 M3. Cisco UCS B200 M3 28. Blade server
Anche per Cisco UCS B200 M3: Manuale di installazione (34 pagine), Nota di installazione e manutenzione (36 pagine), Nota di installazione e manutenzione (37 pagine), Manuale (8 pagine), Manuale di aggiornamento (21 pagine)

Step 1

Required: To install a CPU in an empty socket, remove the protective cap that is intended to prevent bent or touched

contact pins. The pick and pull cap tool provided can be used in a manner similar to a pair of tweezers. Grasp the

protective cap and pivot as shown.

Step 2

Release the catch on the pick and pull tool by pressing the handle/button.

Step 3

Remove the new CPU from the packaging, and load it into the pick and place tool as follows:

a) Confirm that the pedestal is set up correctly for your processor. The pedestal ships configured with the markings

"LGA2011-R1" facing upward, and this is the correct orientation.

b) Place the CPU on the pedestal. The CPU corners should fit snugly at the pedestal corners and the notches should

meet the pegs perfectly.

c) Place the CPU pick and place tool on the CPU pedestal aligned with the A1 arrow pointing to the A1 registration

mark on the pedestal.

d) Press the button/handle on the tool to grasp the CPU.

e) Lift the tool and CPU straight up off of the pedestal.

Figure 12: Loading the Pick and Place Tool

Step 4

Place the CPU and tool on the CPU socket with the registration marks aligned as shown.

Step 5

Press the button/handle on the pick and place tool to release the CPU into the socket.

Alignment mark on the pick and place tool, CPU and

pedestal