Cisco UCS B200 M4 Nota di installazione e manutenzione - Pagina 20

Sfoglia online o scarica il pdf Nota di installazione e manutenzione per Server Cisco UCS B200 M4. Cisco UCS B200 M4 46. For e5-2600 v4 series cpus
Anche per Cisco UCS B200 M4: Nota di installazione e manutenzione (30 pagine), Manuale di aggiornamento (9 pagine), Manuale di manutenzione (24 pagine)

Removing a Blade Server Hard Drive

Before upgrading or adding a drive to a running system, check the service profile in Cisco UCS Manager and

make sure the new hardware configuration will be within the parameters allowed by the service profile.

To prevent ESD damage, wear grounding wrist straps during these procedures.

Caution

Removing a Blade Server Hard Drive

To remove a hard drive from a blade server, follow these steps:

Procedure

Step 1

Push the button to release the ejector, and then pull the hard drive from its slot.

Step 2

Place the hard drive on an antistatic mat or antistatic foam if you are not immediately reinstalling it in another

server.

Step 3

Install a hard disk drive blank faceplate to keep dust out of the blade server if the slot will remain empty.

To install a hard drive in a blade server, follow these steps:

Procedure

Step 1

Place the hard drive lever into the open position by pushing the release button.

Figure 5: Installing a Hard Drive in a Blade Server

Cisco UCS B200 M4 Blade Server Installation and Service Note

Servicing a Blade Server