Cisco UCS B460 M4 Nota di installazione e manutenzione - Pagina 14

Sfoglia online o scarica il pdf Nota di installazione e manutenzione per Server Cisco UCS B460 M4. Cisco UCS B460 M4 46. Blade server
Anche per Cisco UCS B460 M4: Scheda tecnica (7 pagine), Manuale di avvio rapido (2 pagine), Manuale di avvio rapido (5 pagine), Nota di installazione e manutenzione (50 pagine)

Buttons

LED

Health

(Disk Drive)

Buttons

The Reset button is recessed in the front panel of the server. You can press the button with the tip of a paper

clip or a similar item. Hold the button down for five seconds, and then release it to restart the server if other

methods of restarting do not work.

The locator function for an individual server may get turned on or off by pressing the locator button/LED.

The front-panel power button is disabled by default. It can re-enabled through Cisco UCS Manager. After it's

enabled, The power button allows you to manually take a server temporarily out of service but leave it in a

state where it can be restarted quickly. If the desired power state for a service profile associated with a blade

server is set to "off," using the power button or Cisco UCS Manager to reset the server will cause the desired

power state of the server to become out of sync with the actual power state and the server may unexpectedly

shut down at a later time. To safely reboot a server from a power-down state, use the Boot Server action in

Cisco UCS Manager.

The local console connector allows a direct connection to a blade server to allow operating system installation

and other management tasks to be done directly rather than remotely. The port uses the KVM dongle cable

that provides a connection into a Cisco UCS blade server; it has a DB9 serial connector, a VGA connector

for a monitor, and dual USB ports for a keyboard and mouse. With this cable, you can create a direct connection

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs

Color

Description

Off

Can mean either no fault detected or the drive is not

installed.

Flashing Amber

Rebuild drive active.

4 hz

If the Activity LED is also flashing amber, a drive rebuild

is in progress.

Amber

Fault detected.

Overview