Cisco UCS B460 M4 설치 및 서비스 참고 사항 - 페이지 14
{카테고리_이름} Cisco UCS B460 M4에 대한 설치 및 서비스 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS B460 M4 46 페이지. Blade server
Cisco UCS B460 M4에 대해서도 마찬가지입니다: 데이터시트 (7 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (5 페이지), 설치 및 서비스 참고 사항 (50 페이지)
페이지 인쇄
Buttons
LED
Health
(Disk Drive)
Buttons
The Reset button is recessed in the front panel of the server. You can press the button with the tip of a paper
clip or a similar item. Hold the button down for five seconds, and then release it to restart the server if other
methods of restarting do not work.
The locator function for an individual server may get turned on or off by pressing the locator button/LED.
The front-panel power button is disabled by default. It can re-enabled through Cisco UCS Manager. After it's
enabled, The power button allows you to manually take a server temporarily out of service but leave it in a
state where it can be restarted quickly. If the desired power state for a service profile associated with a blade
server is set to "off," using the power button or Cisco UCS Manager to reset the server will cause the desired
power state of the server to become out of sync with the actual power state and the server may unexpectedly
shut down at a later time. To safely reboot a server from a power-down state, use the Boot Server action in
Cisco UCS Manager.
Local Console Connection
The local console connector allows a direct connection to a blade server to allow operating system installation
and other management tasks to be done directly rather than remotely. The port uses the KVM dongle cable
that provides a connection into a Cisco UCS blade server; it has a DB9 serial connector, a VGA connector
for a monitor, and dual USB ports for a keyboard and mouse. With this cable, you can create a direct connection
Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs
6
Color
Description
Off
Can mean either no fault detected or the drive is not
installed.
Flashing Amber
Rebuild drive active.
4 hz
If the Activity LED is also flashing amber, a drive rebuild
is in progress.
Amber
Fault detected.
Overview