Cisco VG202 Manuale di configurazione del software - Pagina 23

Sfoglia online o scarica il pdf Manuale di configurazione del software per Porta d'ingresso Cisco VG202. Cisco VG202 50. Voice gateways
Anche per Cisco VG202: Manuale di installazione dell'hardware (50 pagine), Manuale (10 pagine), Manuale di installazione dell'hardware (48 pagine), Manuale di avvio rapido (19 pagine)

Cisco VG202 Manuale di configurazione del software
Chapter 3
Configuring with the Command-Line Interface

Verifying the Hostname and Password

To verify that you configured the correct hostname and password, follow these steps:
Enter the show config command:
Step 1
VG(config)# show config
Using 1888 out of 126968 bytes
!
version XX.X
.
.
.
!
hostname VG204
!
enable secret 5 $1$60L4$X2JYOwoDc0.kqa1loO/w8/
.
.
.
Check the hostname and encrypted password displayed near the top of the command output.
Step 2
Exit global configuration mode and attempt to reenter it, using the new enable password:
VG# exit
.
.
.
VG con0 is now available
Press RETURN to get started.
VG> enable
Password: guessme
VG#
If you are having trouble, ensure the following:
Tip

Configuring Fast Ethernet Interfaces

To configure a Fast Ethernet interface, use the configuration software provided with your Cisco VG.
Otherwise, for greatest power and flexibility, use configuration mode (manual configuration).
This section describes basic Fast Ethernet interface configuration, including enabling the interface and
specifying IP routing. Depending on your own requirements and the protocols you plan to route, you
might also need to enter other configuration commands.
Before you begin configuring the interfaces, make sure to do the following:
OL-16191-01
Caps Lock is off.
You entered the correct passwords. Passwords are case sensitive.
Connect a console to the Cisco VG.
Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide
Configuring Fast Ethernet Interfaces
3-3