Cisco VG202 Yazılım Yapılandırma Kılavuzu - Sayfa 23

Ağ Geçidi Cisco VG202 için çevrimiçi göz atın veya pdf Yazılım Yapılandırma Kılavuzu indirin. Cisco VG202 50 sayfaları. Voice gateways
Ayrıca Cisco VG202 için: Donanım Kurulum Kılavuzu (50 sayfalar), Manuel (10 sayfalar), Donanım Kurulum Kılavuzu (48 sayfalar), Hızlı Başlangıç Kılavuzu (19 sayfalar)

Chapter 3

Configuring with the Command-Line Interface

Verifying the Hostname and Password

To verify that you configured the correct hostname and password, follow these steps:

Enter the show config command:

Step 1

VG(config)# show config

Using 1888 out of 126968 bytes

version XX.X

hostname VG204

enable secret 5 $1$60L4$X2JYOwoDc0.kqa1loO/w8/

Check the hostname and encrypted password displayed near the top of the command output.

Step 2

Exit global configuration mode and attempt to reenter it, using the new enable password:

VG# exit

VG con0 is now available

Press RETURN to get started.

VG> enable

Password: guessme

VG#

If you are having trouble, ensure the following:

Tip

•

To configure a Fast Ethernet interface, use the configuration software provided with your Cisco VG.

Otherwise, for greatest power and flexibility, use configuration mode (manual configuration).

This section describes basic Fast Ethernet interface configuration, including enabling the interface and

specifying IP routing. Depending on your own requirements and the protocols you plan to route, you

might also need to enter other configuration commands.

Before you begin configuring the interfaces, make sure to do the following:

•

OL-16191-01

Caps Lock is off.

You entered the correct passwords. Passwords are case sensitive.

Connect a console to the Cisco VG.

Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide

Configuring Fast Ethernet Interfaces

3-3