DIGMESA FC Manuale d'uso - Pagina 4
Sfoglia online o scarica il pdf Manuale d'uso per Controllore DIGMESA FC. DIGMESA FC 12. Flow controller
2.1
Connection input plug FC-slot A
1.
Remove the MSD with 4 contacts by pushing out the plug
on the rear side of the MSD.
2.
Remove the plastic screw
parts in the order in which you removed them over the cable, followed, finally,
by the housing . Expose the 3 wires of the cable (3-core, max 0.25 mm
section) by cutting back the cable sheath over a length of approx. 15 mm. Then
strip the insulation from the individual wires over a length of approx. 5 mm.
3.
Now screw the three wires into the corresponding terminals:
Positive (Digmesa colour code: brown) into terminal 1. Negative (Digmesa
colour code: green) into terminal 2. Connect the signal of the flowmeter
(Digmesa colour code: white) to the terminal with the earthing symbol. Note
down the colours of the cables so that you will be able to then correctly
connect the measuring devise (colours of the wires may vary from country to
country). Please note that terminal 3 is required only in conjunction with the
FC programmer.
Plug with 4 contacts
4.
Plug the rubber seal
plug the plug with the earthing symbol onto the earth-
ing symbol FC-slot A. Guide the housing
plug
tighten with the fixing screw
5.
Guide rubber seal
over the cable into the housing
that the cable is held firmly and tightly.
and plug
so that the cable outlet is at the right. Now
, washer
, washer
and rubber seal
Figure 1
onto FC
FC- - - - - slot A
FC
FC
FC
slot A and
slot A
slot A
slot A
.
and plastic screw
and tighten them so
Page 4
with the fixing screw
. Pull the individual
Plug with 4 contacts
Housing
Fixing screw
Rubber seal, round
Washer
Plastic screw
Rubber seal, rectangular
over the
cross-
2
FC-slot A