DIGMESA FC Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Контролер DIGMESA FC. DIGMESA FC 12 сторінок. Flow controller

Друкувати сторінку

2.1

Connection input plug FC-slot A

Remove the MSD with 4 contacts by pushing out the plug

on the rear side of the MSD.

Remove the plastic screw

parts in the order in which you removed them over the cable, followed, finally,

by the housing . Expose the 3 wires of the cable (3-core, max 0.25 mm

section) by cutting back the cable sheath over a length of approx. 15 mm. Then

strip the insulation from the individual wires over a length of approx. 5 mm.

Now screw the three wires into the corresponding terminals:

Positive (Digmesa colour code: brown) into terminal 1. Negative (Digmesa

colour code: green) into terminal 2. Connect the signal of the flowmeter

(Digmesa colour code: white) to the terminal with the earthing symbol. Note

down the colours of the cables so that you will be able to then correctly

connect the measuring devise (colours of the wires may vary from country to

country). Please note that terminal 3 is required only in conjunction with the

FC programmer.

Plug with 4 contacts

Plug the rubber seal

plug the plug with the earthing symbol onto the earth-

ing symbol FC-slot A. Guide the housing

plug

tighten with the fixing screw

Guide rubber seal

over the cable into the housing

that the cable is held firmly and tightly.

and plug

so that the cable outlet is at the right. Now

, washer

and rubber seal

Figure 1

onto FC

FC- - - - - slot A

slot A and

slot A

and plastic screw

and tighten them so

Page 4

with the fixing screw

. Pull the individual

Plug with 4 contacts

Housing

Fixing screw

Rubber seal, round

Washer

Plastic screw

Rubber seal, rectangular

over the

cross-

FC-slot A