Acuity Brands Lighting 5BPMW LED Istruzioni per l'installazione - Pagina 3

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Unità di controllo Acuity Brands Lighting 5BPMW LED. Acuity Brands Lighting 5BPMW LED 5. 6"/5"/4" baffle led module

Stampa la pagina
Step 2: Grounding Wire
NOTE – DO NOT LET THE MODULE HANG UNSUPPORTED BY THE ORANGE
CONNECTOR (Figure 8)
A.
Recessed housing with grounding wire:
1.
Cut off the grounding wire eyelet from the LED module.
2.
Pair the LED module's bare copper grounding wire with the grounding wire from
the recessed housing and secure with a wire nut.
B.
Recessed housing without grounding wire:
1.
Install the grounding wire eyelet into a 8-18 x 3/8" screw (Lithonia Lighting
housings). Or,
2.
Install the eyelet through an 8-18 or equivalent self-tapping screw and secure
into the housing wall.
Step 3: Determine Wiring Method (Select one wiring method)
A.
E26 Socket Adapter:
1.
Screw E26 socket adapter into the base socket inside the housing.
2.
Plug the orange connector of E26 socket adapter into the LED module's mating
orange connector (see Figure 9). Or,
B.
LED Connector:
1.
Plug orange connector from the module into the mating orange connector in the
recessed housing. -This type of connection complies with Title 24 (permanent
LED installation). Or,
C.
Hard Wire Connection Kit:
1.
Cut existing socket wires inside the recessed housing close to the socket (discard
socket).
2.
Cut the E26 socket adapter wires close to the screw base (discard screw base).
3.
Match wires from socket adaptor and housing by color and insert each wire into
red splice connector openings until fully seated.
4.
Using pliers, firmly squeeze the metal U-shaped insert into the wires.
5.
Flip the cover closed to secure the connection. (see Figure 10)
6.
Plug orange connector from the module into the mating orange connector in the
recessed housing.
Like option B, this is for permanent LED installation (where required), and meets
regulations such as Title 24.
Step 4: Installation of the module into the recessed housing
A. Torsion springs: Squeeze each torsion spring together and seat them inside the
housing torsion brackets. Release springs, and gently push module into housing until
flush with ceiling. (Figure 11)
B. Spring retention clips: Center the LED module in the housing opening and gently push
the module up into the housing evenly on all sides until flush with ceiling (Figure 12).
NOTE:
• Align the three retention clips with the recessed housing avoiding interference with anything protruding from the housing walls.
• For removal of a recessed LED module with retention clips, pull down and rotate back and forth until free. Use two standard flat blade screw
drivers to pry the module apart from the recessed housing. This will aid in the removal process.
Lithonia Downlighting
One Lithonia Way / Conyers, GA 30012
800-315-4935 / www.lithonia.com
INSTALLATION INSTRUCTIONS
6BPMW LED (6" Baffle LED Module); 5BPMW LED (5" Baffle LED Module)
4BPMW LED (4" Baffle LED Module)
Orange
connector
eyelet
Socket
adapter
Figure 9
Red splice
connector
Figure 10
Figure 11
Part No. CJ5201106 Rev. E
©20011 Acuity Brands Lighting, Inc., 12/11
Figure 8
Figure 12
Page 3 of 5