Acuity Brands Lighting 5BPMW LED 설치 지침 - 페이지 3

{카테고리_이름} Acuity Brands Lighting 5BPMW LED에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Acuity Brands Lighting 5BPMW LED 5 페이지. 6"/5"/4" baffle led module

페이지 인쇄

Step 2: Grounding Wire

NOTE – DO NOT LET THE MODULE HANG UNSUPPORTED BY THE ORANGE

CONNECTOR (Figure 8)

Recessed housing with grounding wire:

Cut off the grounding wire eyelet from the LED module.

Pair the LED module's bare copper grounding wire with the grounding wire from

the recessed housing and secure with a wire nut.

Recessed housing without grounding wire:

Install the grounding wire eyelet into a 8-18 x 3/8" screw (Lithonia Lighting

housings). Or,

Install the eyelet through an 8-18 or equivalent self-tapping screw and secure

into the housing wall.

Step 3: Determine Wiring Method (Select one wiring method)

E26 Socket Adapter:

Screw E26 socket adapter into the base socket inside the housing.

Plug the orange connector of E26 socket adapter into the LED module's mating

orange connector (see Figure 9). Or,

LED Connector:

Plug orange connector from the module into the mating orange connector in the

recessed housing. -This type of connection complies with Title 24 (permanent

LED installation). Or,

Hard Wire Connection Kit:

Cut existing socket wires inside the recessed housing close to the socket (discard

socket).

Cut the E26 socket adapter wires close to the screw base (discard screw base).

Match wires from socket adaptor and housing by color and insert each wire into

red splice connector openings until fully seated.

Using pliers, firmly squeeze the metal U-shaped insert into the wires.

Flip the cover closed to secure the connection. (see Figure 10)

Plug orange connector from the module into the mating orange connector in the

recessed housing.

Like option B, this is for permanent LED installation (where required), and meets

regulations such as Title 24.

Step 4: Installation of the module into the recessed housing

A. Torsion springs: Squeeze each torsion spring together and seat them inside the

housing torsion brackets. Release springs, and gently push module into housing until

flush with ceiling. (Figure 11)

B. Spring retention clips: Center the LED module in the housing opening and gently push

the module up into the housing evenly on all sides until flush with ceiling (Figure 12).

NOTE:

• Align the three retention clips with the recessed housing avoiding interference with anything protruding from the housing walls.

• For removal of a recessed LED module with retention clips, pull down and rotate back and forth until free. Use two standard flat blade screw

drivers to pry the module apart from the recessed housing. This will aid in the removal process.

Lithonia Downlighting

One Lithonia Way / Conyers, GA 30012

800-315-4935 / www.lithonia.com

INSTALLATION INSTRUCTIONS

6BPMW LED (6" Baffle LED Module); 5BPMW LED (5" Baffle LED Module)

4BPMW LED (4" Baffle LED Module)

Orange

connector

eyelet

Socket

adapter

Figure 9

Red splice

connector

Figure 10

Figure 11

Part No. CJ5201106 Rev. E

Figure 8

Figure 12

Page 3 of 5