DiMarzio angel dp232 Istruzioni per l'installazione - Pagina 4
Sfoglia online o scarica il pdf Istruzioni per l'installazione per Strumento musicale DiMarzio angel dp232. DiMarzio angel dp232 4.
Stampa la pagina1388 Richmond Terrace • PO Box 100387
Staten Island, NY 10310
www.dimarzio.com
FIG. 11
Pickup Output Jack
Clamp Screw Head
Clamp Screw
Clamp
FIG. 12
THE ANGEL™ SYSTEM DP232
INSTALLATION INSTRUCTIONS − page 4
INSTALLING THE ANGEL™ PICKUP
Loosen the clamp screws on both ends of the pickup top plate using a small Phillips
screwdriver until the clamps are open wide enough to mount the pickup on the top of the
guitar. [SEE FIG. 11] Then slide the pickup into the soundhole.
For small soundholes, it may be necessary to remove one or both clamps, slide
the pickup into place, and then reassemble the clamp(s) once the pickup is
correctly positioned. When reassembling the clamps, be sure they slide into the
slots molded into the pickup housing.
We recommend installing the pickup as close to the bottom edge of the ngerboard
(towards the neck) as possible.
Adjust the pickup so that it is centered in the soundhole and the pole pieces are aligned
with the strings. [SEE FIG. 12] A slight mismatch between your guitar's string spacing and the
spacing of the pole pieces will not affect performance.
Tighten the clamp screws rmly, but do not over-tighten. Over-tightening can damage the
pickup or guitar nish.
Once the pickup is securely installed, plug the cable from the preamp into the pickup
output jack. Restring your guitar and you're ready to play.
PLAYING THE ANGEL™ SYSTEM
Plug your guitar cable into the endpin jack to power up the preamp. Before plugging The
Angel™ System into the ampli er, turn the ampli er volume all the way down. Adjust The
Angel™ volume controls in the soundhole all the way up, then adjust your amp volume to the
maximum level you want. The blend of the Nano ex and The Angel™ can be adjusted by
reducing either of the volume controls. It is possible to solo either of the pickups by turning the
volume control of the other pickup all the way down.
You can expect about 600 hours of playing and standby time from a fresh alkaline battery, or
as much as 1000 hours from a lithium battery. To extend battery life, unplug the guitar cable
from your guitar when you're finished playing. Remember, the preamp continues to operate
and uses battery power whenever a guitar cable is plugged into your guitar, even if you turn
down the soundhole volume control, unplug the cable from your amp or put your guitar amp
on standby. A weak or distorted sound from The Angel™ System means it's time to replace
your battery.
If you ever experience unexpected battery failure and can't replace the battery before you
have to play, you can play The Angel™ magnetic pickup without a battery by disconnecting
the preamp cable from the pickup and plugging the included 12-foot (3.5 meter) guitar
cable into the pickup. This backup cable connects The Angel™ directly to your amp without
a volume control.
POLE PIECE ADJUSTMENT
The pole pieces of The Angel™ are preset for standard bronze acoustic strings (four wound
strings and two plain), but this setting is only a basic reference point. The pole pieces are
adjustable with the included ⁄ - inch Allen wrench to provide the best balance for your
specific guitar and string set. Raising a pole piece will increase the output from its string, while
lowering it will decrease it.
IMPORTANT: The pole pieces have a maximum downward adjustment range. When you
encounter additional resistance at the bottom of the adjustment range, do not force the
pole piece further. This could result in permanent damage.