Epson 3170 - Perfection Photo Manuale di risoluzione dei problemi - Pagina 4

2. Place slides in the holder, base side facing down as

shown below.

NOTE: The base side of the film is the side where

the film maker's name and film ID numbers can be

read correctly. Also, when you look at an image on

the film from the base side, the image should appear

normal, not reversed.

NOTES:

• Make sure the document cover is completely closed; otherwise you cannot obtain

proper colored images.

• A newton ring (ring-shaped stripe pattern) may appear in the scanned image. To

remove the newton ring, place the film with the base side facing up and preview using

the Thumbnail Preview; then reverse the previewed image by using the Mirroring

button.

SCAN 35 MM NEGATIVES AND FILM STRIPS

2. Place the film holder on the document table so that the

triangle mark on its tab is aligned with the triangle on

the document table. The projection on the tab then goes

into the hole on the document table.

Slide the edge of the strip into the 35 mm film

holder, base side facing down. Then place it so

that the entire frame is positioned inside the film

holder.