Dinex DuraTherm 2011208 Manuale d'uso e manutenzione - Pagina 3
Sfoglia online o scarica il pdf Manuale d'uso e manutenzione per Caricabatterie Dinex DuraTherm 2011208. Dinex DuraTherm 2011208 13. 208v, 3-phase
Stampa la pagina
DuraTherm
• Never use the equipment as a work surface
or cutting board.
• Do not attempt to heat anything other than
a Dinex base.
!
IMPORTANT: Never place a DuraTherm base
or a SmartTherm base in a microwave oven!
!
INFORMATION: This appliance is for
commercial use only and must be used
exclusively for the purposes prescribed.
!
IMPORTANT: The following instructions
reduce the risk of fire, electrical shock, or
injury.
INSTALLATION
SET UP
1. Carefully remove any packing material
from the induction charger and check
loose packing material for small parts
or accessories. Inspect the charger for
concealed damage before placing packing
material aside. Keep the packaging until
you are confident with the equipment
performance.
2. The DuraTherm™ induction charger is
equipped with a locking plug. This plug
is part of a system that will protect you
from injury in the event of an electrical
malfunction inside the unit. Be sure the plug
is fully plugged into a matching socket that
is properly grounded.
!
ATTENTION: DO NOT cut or break off the
larger angled prong on this plug, or change the
plug or power in any way. Doing so will create
a safety hazard and also void the warranty.
3. MAKE SURE THAT INCOMING
VOLTAGES MATCHES THE CHARGER
™
REQUIREMENTS. A product identification
label on the bottom of the unit specifies
the operating voltage, current, frequency,
phase, and maximum wattage of the
charger. Plugging or wiring the charger into
less voltage than the charger is rated may
significantly decrease the performance
of the unit or damage internal electrical
components.
4. Do not place foreign objects on the charger,
or between the Dinex base and the charger
surface. Foreign objects may heat within
the induction field and cause damage to the
charger surface and/or base.
5. Do not use any DuraTherm
a damaged cord or plug. Consult the warranty
and follow the instructions for service.
6. Do not let the power cord touch hot surfaces.
7. The center of the charger may get hot to the
touch after hours of continuous use. Use
caution when loading and unloading bases.
8. The charger requires ample air flow to cool
the internal electronic components. Air is
pulled in from the bottom of the unit from
the front and sides, and exhausted towards
the rear of the unit. Assure that nothing
obstructs the airflow about all four sides of
the unit. Allow at least two inches from a
wall or partition.
9. A dedicated electrical outlet is recommended
for EACH DuraTherm
!
IMPORTANT: Every installation site has
different electrical wiring requirement. Because
many different local codes exist, it is the owner
and installer's responsibility to comply with all
federal, state, and local codes. Dinex
responsible for any consequential damages,
either expressed or implied, as a result of
charger that has
™
charger.
™
is not
®
3