Aeotec TriSensor AEOEZWA005 Manuale - Pagina 3

Sfoglia online o scarica il pdf Manuale per Automazione domestica Aeotec TriSensor AEOEZWA005. Aeotec TriSensor AEOEZWA005 7.

Stampa la pagina

19/11/2020

Outdoor installation.

Please note that when installed outdoors of your home, your TriSensor should only be relied on for temperature and light where as the motion sensing

capabilities should be disabled on your gateway in order to avoid false motion readings. If selecting an outdoor location, it s important to position your

TriSensor in a sheltered location. It is best if your TriSensor is not directly exposed to rain, snow, or other elements.

If you wish to use TriSensor outdoors, you will need to lower settings, and angle TriSensor accordingly as all environments will require different solutions

or different settings for the motion sensor to work properly. Parameter 3 [1 byte] will determine the sensitivity of the motion sensor from a value range of 0

disabled to 11 max sensitivity (your ability to configure this setting will depend on the gateway used).

It is advised that if you are seeing false motion tracking, run trial and error to determine the best sensitivity from a range of 0 - 11 by going down 1 sensitivity

level after every test (first 5, 4, 3, 2, then 1), while setting Parameter 3 [2 byte] to 5 to allow a PIR sensor timeout of 5 seconds after detecting motion to

rapidly determine the best settings for motion use outdoors.

Reset to factory default

Inclusion

Exclusion

NIF

Wakeup

Protection

FirmwareUpdate

SetAssociation

Association Groups:

Group Number

Configuration Parameters

Parameter 1: Motion Retrigger Time

This parameter is configured the delay time before PIR sensor can be triggered again to reset motion timeout counter.

Size: 2 Byte, Default Value: 30

Setting

1 - 32767

Parameter 2: Motion Clear Time

This parameter is configured the time to clear motion event after a motion event detected. Time to motion clear, the device will send a clear event report to

controller and send BASIC_SET= 0x00 to nodes associated in group 2.

Size: 2 Byte, Default Value: 240

Setting

1 - 32767

Parameter 3: Motion Sensitivity

This parameter is configured the sensitivity that motion detect. 0PIR sensor disabled.

Size: 1 Byte, Default Value: 11

Setting

1 - 11

Parameter 4: Binary Sensor Report Enable

Size: 1 Byte, Default Value: 0

manuals-backend.z-wave.info/make.php?lang=en&sku=AEOEZWA005&cert=ZC10-18046087&type=mini

1. Power up the device.

2. Press and hold the button for 15s until Red Led is blinking,then release the button

1. Open the battery compartment.

2. Press the button once.

1. Open the battery compartment.

2. Press the button once.

XXXNIF

Press and hold the button at least 2s until Red Led is on and then release the button,device will send

wakeup notification to controller if device is in a Z-Wave network.

XXXProtection

XXXFirmwareUpdate

XXXSetAssociation

Maximum

Description

Nodes

Lifeline

Controlling group, all nodes associated in this group will be controlled through BASIC_SET

command by the device when device detects a movement event. Basic Set Value is decided

by Configuration Parameter 6.

Controlling group, all nodes associated in this group will be controlled through BASIC_SET

command by the device when device detects an ambient temperature alarm (Decided by

Configuration Parameter 7).

Description

Will disable PIR sensor from triggering until motion timeout has finished.

Time in seconds

Description

Second

Description

Disable

Sensitivity.

3/7