Aeotec MultiSensor 7 Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Sensori di sicurezza Aeotec MultiSensor 7. Aeotec MultiSensor 7 5.
Anche per Aeotec MultiSensor 7: Manuale d'uso (8 pagine)

Stampa la pagina

3. It will be solid

yellow

during inclusion, and flash

Advanced Functions.

Z-Wave Resetting MultiSensor 7.

Your MultiSensor can be removed from your Z-Wave network at any time. You'll need to use your Z-Wave network's main controller to do this and the follo

this. If you are using other products as your main Z-Wave controller, please refer to the part of their respective manuals that tells you how remove devices

Using an existing gateway:

You may need to refer to your gateway's method of including devices if you do not know how to pair a Z-Wave device. You may use any gateway to pe

MultiSensor 7 even if they are not paired together to factory reset MultiSensor 7.

1. Set your Z-Wave gateway into Z-Wave unpair (exclusion) mode.

2. Tap the action button once; the

3. If removed successful, the

Manual Hard Resetting MultiSensor 7.

This method is not fully advised unless your gateway has failed, if paired to your network, performing these steps will factory reset your MultiSensor 7, but

phantom/ghost device in your working Z-Wave network.

1. Make sure the device has been powered.

2. Press and hold the button for 20 seconds. When the red led flash, the device will enter factory reset mode.

white/green

3 times if paired successfully. If it fails, it will flash

purple

led will light up.

blue

led will fade in and out to indicate it is ready to be paired to a new hub.

white/red

instead.