Aeotec MultiSensor 7 Podręcznik użytkownika - Strona 4
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Czujniki bezpieczeństwa Aeotec MultiSensor 7. Aeotec MultiSensor 7 5 stron.
Również dla Aeotec MultiSensor 7: Podręcznik użytkownika (8 strony)
Drukuj stronę
3. It will be solid
yellow
during inclusion, and flash
Advanced Functions.
Z-Wave Resetting MultiSensor 7.
Your MultiSensor can be removed from your Z-Wave network at any time. You'll need to use your Z-Wave network's main controller to do this and the follo
this. If you are using other products as your main Z-Wave controller, please refer to the part of their respective manuals that tells you how remove devices
Using an existing gateway:
You may need to refer to your gateway's method of including devices if you do not know how to pair a Z-Wave device. You may use any gateway to pe
MultiSensor 7 even if they are not paired together to factory reset MultiSensor 7.
1. Set your Z-Wave gateway into Z-Wave unpair (exclusion) mode.
2. Tap the action button once; the
3. If removed successful, the
Manual Hard Resetting MultiSensor 7.
This method is not fully advised unless your gateway has failed, if paired to your network, performing these steps will factory reset your MultiSensor 7, but
phantom/ghost device in your working Z-Wave network.
1. Make sure the device has been powered.
2. Press and hold the button for 20 seconds. When the red led flash, the device will enter factory reset mode.
white/green
3 times if paired successfully. If it fails, it will flash
purple
led will light up.
blue
led will fade in and out to indicate it is ready to be paired to a new hub.
white/red
instead.