Whirlpool 7MWTW1950EW Manuale d'uso e manutenzione - Pagina 27

Sfoglia online o scarica il pdf Manuale d'uso e manutenzione per Lavatrice Whirlpool 7MWTW1950EW. Whirlpool 7MWTW1950EW 33. Top-loading washer
Anche per Whirlpool 7MWTW1950EW: Manuale di istruzioni per l'installazione (16 pagine)

Stampa la pagina

TROUBLESHOOTING

First try the solutions suggested here or consult the warranty sheet in the washer for assistance and to possibly avoid a service call.

If you experience

Washer Not Performing As Expected

Not enough water in

washer.

Washer won't run or fill,

washer stops working,

or wash light remains

on (indicating that the

washer was unable to fill

appropriately)

Washer not

draining/spinning, loads

are still wet, or spin light

remains on (indicating

that the washer was

unable to pump out

water within 10 minutes)

Possible Causes

Load not completely covered in

water.

Check for proper water supply.

Check proper electrical supply.

Normal washer operation.

Washer may be tightly packed

Small items may have been caught

in pump or between basket and tub,

which can slow draining.

Use a cycle with a low spin speed.

This is normal operation for a low-water washer. The load will

not be completely under water. The washer senses load sizes

and adds correct amount of water for optimal cleaning. Use the

Edredones (Bulky Items) cycle or the Llenado Profundo (Deep

Fill) option for higher water fill. See "What's New under the Lid"

and "Cycle Guide" to match your load with the best cycle.

IMPORTANT: Do not add more water to washer. Adding water

lifts the items off the washplate, resulting in less effective

cleaning.

Run Limpieza Lavadora con affresh® (Clean Washer with

affresh®) to optimize the water level and wash performance due

to soil build-up in washer basket.

Both hoses must be attached and have water flowing to

inlet valve.

Both hot and cold water faucets must be turned on.

Check that inlet valve screens have not become clogged.

Check for any kinks in inlet hoses, which can restrict water flow.

Plug power cord into an earthed outlet.

Do not use an extension cord.

Ensure there is power to outlet.

Reset a tripped circuit breaker. Replace any blown fuses.

NOTE: If problems continue, contact an electrician.

Lid must be closed for washer to run.

Washer will pause during certain phases of cycle. Do not

interrupt cycle.

Remove several items, rearrange load evenly around the

washplate. Close lid and press Inicio/Pausa (Start/Pause).

Add only 1 or 2 additional items after washer has started.

Empty pockets and use garment bags for small items.

Cycles with lower spin speeds remove less water than cycles

with high spin speeds. Use the recommended cycle/spin speed

for your garment. To remove extra water in the load, select

Drenar y Exprimir (Drain & Spin). Load may need to be

rearranged to allow even distribution of the load in the basket.

Solution