Whirlpool 7MWTW1950EW Manual de utilização e cuidados - Página 27

Procurar online ou descarregar pdf Manual de utilização e cuidados para Máquina de lavar roupa Whirlpool 7MWTW1950EW. Whirlpool 7MWTW1950EW 33 páginas. Top-loading washer
Também para Whirlpool 7MWTW1950EW: Manual de instruções de instalação (16 páginas)

TROUBLESHOOTING
First try the solutions suggested here or consult the warranty sheet in the washer for assistance and to possibly avoid a service call.
If you experience
Washer Not Performing As Expected
Not enough water in
washer.
Washer won't run or fill,
washer stops working,
or wash light remains
on (indicating that the
washer was unable to fill
appropriately)
Washer not
draining/spinning, loads
are still wet, or spin light
remains on (indicating
that the washer was
unable to pump out
water within 10 minutes)
Possible Causes
Load not completely covered in
water.
Check for proper water supply.
Check proper electrical supply.
Normal washer operation.
Washer may be tightly packed
Small items may have been caught
in pump or between basket and tub,
which can slow draining.
Use a cycle with a low spin speed.
This is normal operation for a low-water washer. The load will
not be completely under water. The washer senses load sizes
and adds correct amount of water for optimal cleaning. Use the
Edredones (Bulky Items) cycle or the Llenado Profundo (Deep
Fill) option for higher water fill. See "What's New under the Lid"
and "Cycle Guide" to match your load with the best cycle.
IMPORTANT: Do not add more water to washer. Adding water
lifts the items off the washplate, resulting in less effective
cleaning.
Run Limpieza Lavadora con affresh® (Clean Washer with
affresh®) to optimize the water level and wash performance due
to soil build-up in washer basket.
Both hoses must be attached and have water flowing to
inlet valve.
Both hot and cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.
Plug power cord into an earthed outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not
interrupt cycle.
Remove several items, rearrange load evenly around the
washplate. Close lid and press Inicio/Pausa (Start/Pause).
Add only 1 or 2 additional items after washer has started.
Empty pockets and use garment bags for small items.
Cycles with lower spin speeds remove less water than cycles
with high spin speeds. Use the recommended cycle/spin speed
for your garment. To remove extra water in the load, select
Drenar y Exprimir (Drain & Spin). Load may need to be
rearranged to allow even distribution of the load in the basket.
Solution
27