Whirlpool AWI-1300 Manuale di servizio - Pagina 9

Sfoglia online o scarica il pdf Manuale di servizio per Lavatrice Whirlpool AWI-1300. Whirlpool AWI-1300 39.

How to Connect the Inlet Hose

Be careful not to mistake in supplying between the hot(maximum : 50˚C) and cold water.

In using only one water tap or in case of attached one water inlet valve, connect the inlet hose to the cold water inlet

valve.

Do not over tighten : this could cause damage to couplings.

FOR ORDINARY TAP

Pull down the collar

of the inlet hose to

separate it from the

water tap adapter.

Remove the tape,

and screw connector

B into connect A tightly.

Connector A

Connector B

CONNECTION

Loosen the four

screws at the water

tap adapter, but don't

loosen the screws until

they are separated from

the water tap adapter.

Connect the inlet

hose to the water tap

adapter by puling down

the collar of the hose end.

Connect the water tap

adapter to the water tap tight-

en the four screws evenly

while pushing up the adapter

so that the rubber packing

can stick to the water tap

tightly.

Connect the inlet hose adapter

of the hose to the water inlet of

the washer by turning it clock-

wise to be fixed tightly.

• Please check the rubber packing

inside the inlet hose adapter of

the hose.

TAPE