Whirlpool AWI-1300 Service Manual - Page 9
Browse online or download pdf Service Manual for Washer Whirlpool AWI-1300. Whirlpool AWI-1300 39 pages.
Print Page
How to Connect the Inlet Hose
Be careful not to mistake in supplying between the hot(maximum : 50˚C) and cold water.
In using only one water tap or in case of attached one water inlet valve, connect the inlet hose to the cold water inlet
valve.
Do not over tighten : this could cause damage to couplings.
FOR ORDINARY TAP
1
Pull down the collar
of the inlet hose to
separate it from the
water tap adapter.
4
Remove the tape,
and screw connector
B into connect A tightly.
Connector A
Connector B
CONNECTION
8
2
Loosen the four
screws at the water
tap adapter, but don't
loosen the screws until
they are separated from
the water tap adapter.
5
Connect the inlet
hose to the water tap
adapter by puling down
the collar of the hose end.
3
Connect the water tap
adapter to the water tap tight-
en the four screws evenly
while pushing up the adapter
so that the rubber packing
can stick to the water tap
tightly.
6
Connect the inlet hose adapter
of the hose to the water inlet of
the washer by turning it clock-
wise to be fixed tightly.
• Please check the rubber packing
inside the inlet hose adapter of
the hose.
TAPE