Acom 1200S Manuale operativo - Pagina 9

Sfoglia online o scarica il pdf Manuale operativo per Amplificatore Acom 1200S. Acom 1200S 11. Hf + 6 m linear amplifier

The transceiver manufacturers give different names to this input, for example: TX-INHIBIT, MUTE,

LINEAR, and others. Check the manual of your transceiver. Approach your dealer for details. If your

transceiver has no such input, do not worry – ACOM 700S will operate normally with KEY-OUT

unconnected.

d) RF INPUT - Connect a coaxial cable with a PL-259 plug from the transceiver output

(antenna jack) to the amplifier RF INPUT jack.

In order to avoid at damage, turn off your transceiver's internal antenna tuner.

e) RF OUTPUT - Connect a suitable coaxial cable with a PL-259 plug from the RF OUTPUT

on the rear amplifier panel to the antenna switch, tuner or antenna intended for the

respective frequency band.

We recommend using RG213 or better. Consult your local coax cable supplier.

Preparation of the mains outlet for the amplifier, requirements for the installation and

the mains voltage.

It is preferable to use the mains outlet closest to the source. Make sure that the respective fuses and

voltage, of your power mains match the ACOM 700S amplifier's specifications (see S. 8-1(g)).

g) Main fuses.

h) Power cord inlet. Due to different mains standards in different countries, the

ACOM 700S is delivered without a power plug for the mains cable. You dealer might

be able to provide the correct Safety Class I plug. The ground lead of the power cable

is colored yellow with two green stripes. If you have any doubts about the correct way

to connect these wires, consult your dealer.

8 8

If you use an amplifier for the first time in your shack, pay serious

attention to the size of coaxial cable from your amplifier output

to the antenna. The cable must be capable of handling the

increased power safely, particularly on the 10m and 6m bands.

This warning applies equally for the antenna switch, tuner, and

the whole antenna system, especially when using multi-band trap

antennas.

Before connecting your amplifier to the power grid, be sure

that the outlet is correctly wired and is capable of providing the

required current i.e. (up to 10A from 200/240VAC mains and up to

16A from 100/120VAC mains). Also make sure that the grounding

lead is connected properly in the outlet, intended for the amplifier.

If subsequently you connect the amplifier to a different outlet,

check it as well.

Make sure you check whether the main fuses installed in

your amplifier correspond to your local mains nominal voltage

and if necessary replace them as described in Section 7-2!

C A U T I O N