FirePro FPC-2 Manuale di funzionamento e manutenzione - Pagina 7

Sfoglia online o scarica il pdf Manuale di funzionamento e manutenzione per Controllore FirePro FPC-2. FirePro FPC-2 7. Fire control panel system isolation
Anche per FirePro FPC-2: Manuale di funzionamento e installazione (14 pagine), Manuale di funzionamento e manutenzione (8 pagine), Manuale di avvio rapido (2 pagine)

5. Panel Operation

Silence/Sound alarm

The

button is a full reset on the FPC-2 panel only.

The control panel requires 24v DC.

Exceeding the maximum power supply rating may cause a fuse or other protective device to operate and render

the equipment inoperative until the fuse is replaced or protective devices are reset.

FPC-2 control panels do not require any specific maintenance but should the control panel become dirty it can be

wiped over with a damp cloth and should then be dried with a dry, lint free cloth. Detergents or solvents should

not be used to clean the panel and care must be taken that water does not

Testing of the extinguishant system should only be carried out by trained personnel and must be done with

appropriate isolation measures in place to ensure that accidental discharge of the extinguishant agent is avoided

and any malfunction should be reported to the fire alarm maintenance company immediately.

8. Commissioning & Testing

Before applying power to the panel, igniting actuators must be physically isolated from the system by disconnecting

both wires to it. This will prevent any accidental release of extinguishant.

When power is applied, if all connections are correct, only the green Power should be lit. If any fault indicators

are lit the wiring to the appropriate input or output should be checked and all faults have been cleared before

proceeding.

TESTING

DISCONNECT ALL FIREPRO AEROSOL GAS GENERATORS BEFORE TESTING.

Do not leave any FirePro gas generators connected to the unit when testing or these units will activate.

TO TEST SYSTEM:

Step 1 Turn Power off

Step 2 Disconnect FirePro units and connect test lamps

Step 3 Visually inspect each FirePro unit installed and

ensure BKF and mounting bolts are intact. The

FirePro® unit must be clean and free of debris

Step 4 Inspect all other component detectors, sirens

etc. Inspect cable for any signs of damage.

Step 5 Turn power on to panel and test detection

system to simulate activation-all test lamps to

be lit.

Step.6 Turn off power – Reconnect all FirePro units

Step.7 Turn power on – Testing is complete

Note: If the system has been activated the system activation fuse needs to be inspected as blown fuse will show

as a fault. The Fuse is 1.6AMP Quick Blow.

fp_c2_m5.3

button will only silence the buzzer in the FPC-2 unit.

Enter

the enclosure.

Page 7 of 7