Ergo EMPRO-WM175B Manuale di istruzioni - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per Cremagliere e cavalletti Ergo EMPRO-WM175B. Ergo EMPRO-WM175B 13. Flat panel swing out arm

4
Mounting slot
Flat Washer
Upper Mounting Channel
5/16" Lag Bolt
1/2" Socket Wrench
NB. Before drilling the second mounting hole, re-
level the mount.
Drill a pilot hole at the marked location using a
7
1
power drill and a 1/4" drill bit.
Align the mounting slot with the drilled hole.
3 8
Insert and tighten one 5/16" x 3" lag bolt and fl at
9
3
washer. Tighten using a 1/2" socket wrench. Do not
completely tighten the lag bolt at this time.
Re-level the EMPRO-WM175B.
10
Using a 1/2" socket wrench completely tighten the two
11
upper lag bolts.
DO NOT over-tighten lag bolts when attaching the
mount to the wall. Improper installation may result in
personal injusry or damage to property.
NB. A minimum of two wall studs must be used in the
installation of this product.
Repeat these steps to secure the lower mounting
channel to the wall.
NB. There will be a total of four mounting points (2
for the upper mounting channel and 2 for the lower
mounting channel).
If the studs are 12" apart, use three 3" lag bolts for the
upper mouting channel and three 3" lag bolts for the
lower mounting channel. If the studs are 16", 18" or
24" apart, use two 3" lag bolts for the upper mounting
channel and two 3" lag bolts for the lower mounting
channel.
1 7