Ergo EMPRO-WM175B 사용 설명서 - 페이지 4

{카테고리_이름} Ergo EMPRO-WM175B에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ergo EMPRO-WM175B 13 페이지. Flat panel swing out arm

Mounting slot

Flat Washer

Upper Mounting Channel

5/16" Lag Bolt

1/2" Socket Wrench

NB. Before drilling the second mounting hole, re-

level the mount.

Drill a pilot hole at the marked location using a

power drill and a 1/4" drill bit.

Align the mounting slot with the drilled hole.

3 8

Insert and tighten one 5/16" x 3" lag bolt and fl at

washer. Tighten using a 1/2" socket wrench. Do not

completely tighten the lag bolt at this time.

Re-level the EMPRO-WM175B.

Using a 1/2" socket wrench completely tighten the two

upper lag bolts.

DO NOT over-tighten lag bolts when attaching the

mount to the wall. Improper installation may result in

personal injusry or damage to property.

NB. A minimum of two wall studs must be used in the

installation of this product.

Repeat these steps to secure the lower mounting

channel to the wall.

NB. There will be a total of four mounting points (2

for the upper mounting channel and 2 for the lower

mounting channel).

If the studs are 12" apart, use three 3" lag bolts for the

upper mouting channel and three 3" lag bolts for the

lower mounting channel. If the studs are 16", 18" or

24" apart, use two 3" lag bolts for the upper mounting

channel and two 3" lag bolts for the lower mounting

channel.

1 7