Direct Healthcare Group GATE EASY HighBack Manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale d'uso per Sedia a rotelle Direct Healthcare Group GATE EASY HighBack. Direct Healthcare Group GATE EASY HighBack 12.

Stampa la pagina

14. Cleaning

Clean the Easy hygiene chair with detergent/disinfectants commonly used

in healthcare (alcohol-based). The pillars should be cleaned with agents that

dissolve grease and also remove lime stains. Raise the chair to maximum

height when cleaning the pillars. Apply the cleaning agent and leave it to

work according to the instructions (also allow it to run down inside the

pillars); flush out. NOTE: Also clean the pillar base plate periodically. Do

so by removing the bottom plug (see fig. 17) and applying cleaning agent

directly in the pillar. Allow to work; flush out.

Read the warning text on the packaging/cleaning agents and in their

data sheets.

NOTE: To avoid crush injuries, make sure protective covers (fig. 19)

are always put back

15. Troubleshooting when the chair is inoperable

NOTE: Chair cannot be operated above 65 cm seat height if the chair is

tilted forward, nor can the seat be tilted forward if seat height is greater than

65 cm.

Before troubleshooting begins, always restart the battery (see page

4. Hold in the battery's OFF button for approx. 5 seconds. Wait for

one minute. Activate the battery using the ON button).

1 Check the battery charge via

the remote control's battery

indicator (if necessary, activate

the remote control by pressing

any button).

1a Indicator shows green ==>

Calibrate the chair (See page

7 ).

1b Indicator shows red == >

Charge the battery

1c Indicator lamp out ==>

Connect the remote

control to the charger. If

charging is indicated in the

remote control, charge the

battery as per instructions. If

charging is not indicated,

proceed to 2.

If the chair remains in operable following completion of the above, contact

customer service at GATE.

EA SY HI GH BA CK

2 Switch off the battery manually

using the battery Off button

(see page 4). Wait one

minute. Activate the battery

by pressing its On button (see

page 4). Check that the battery

indicator lamp is lit or flashing

Indicator lamp lit/flashing == >

Replace remote control

and charge the battery as per

the instructions.

Indicator lamp not lit, not

flashing ==> Replace the

battery

G ATE RD .SE