Direct Healthcare Group GATE EASY HighBack Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Sedia a rotelle Direct Healthcare Group GATE EASY HighBack. Direct Healthcare Group GATE EASY HighBack 12.

Stampa la pagina

9. Installing seat with the rear opening (accessory)

The seat comprises two halves that are snapped in place with the aid of clamps

on the seat's underside.

10. Sanitary pan

The sanitary pan is slid into position from behind between the seat and wire

guides as shown in fig. 9. Make sure the sanitary pan is slid into position above

the wire guides. Also make sure that the pan assumes the right position in relation

to the cutout/seat and that the pan's rear hook locks into the guide (see figs. 9

and 10).

11. Footrest / Heel restraint

The foot rest can be easily set to the preferred height, swung aside (lift/swing) or

removed (lift away). Set footrest height by moving the green clip to the preferred

hole.

12. Castors

The Easy Hygiene Chair can feature 2 different types of wheels. The images show

the options.

A) Single wheel 125mm

The Hygiene Chair has 4 wheels (full brakes). The wheel on the right-hand front

side (grey brake pad) also features a directional lock (see image 14 - brake

position 1 - directional lock, brake position 2 - full brake).

B) Double wheel, 100mm

The Hygiene Chair has 4 wheels, of which the one on the righthand front side

features a directional lock (see image 15) and the other 3 are fitted with full

brakes.

When the directional lock is activated, wheels cannot be turned. This is

particularly useful when moving heavier patients. The chair is thus significantly

easier for staff to push and control. The directional lock should be released

when manoeuvring in tight spaces. The other wheels (x 3)/green brake pad are

conventional wheels that lock both directionally and rotationally when the brakes

are applied (see image 16, image 17).

13. Calibrating the actuators

The actuators are normally calibrated automatically every time the chair reaches

its end position (min height, max tilt). IF the chair still does not run parallel, or if the

tilt function does not seem to work, an ACTIVE calibration should be performed.

Do this by holding down the <slow/up>+ <slow/down> buttons simultaneously.

After around 15 sec., the chair will move to its end position i.e. minimum height

and maximum rearwards tilt Hold down the buttons until the end positions are

reached. Release the buttons and wait five sec. The chair is now calibrated and

can be used again.

Calibration should NOT be done while user is in the chair. Note that all three actuators move during the calibration

phase. If not, stop calibration immediately and contact customer service/GATE (or your local dealer).

U S ER MANUA L

G ATE RD .SE