Alcovisor JUPITER X Manuale di istruzioni - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per Apparecchiature di prova Alcovisor JUPITER X. Alcovisor JUPITER X 12.

OPERATING INSTRUCTIONS

Pre-test Conditions

1. Operating temperature range is -10° C to 50° C. Use within this temperature

range will limit condensation from a subject breath to insure an accurate

reading from a breath sample.

2. It is recommended that the operator to observe a subject for about 20 minutes

before administering the breath test to insure that nothing is consumed or

expelled from the mouth of the subject.

eliminate reading from mouth alcohol.

3. To ensure the fuel cell is kept in good condition, turn off the device after use

and store it in appropriate condition.

Standard Test

1. Attach a disposable mouthpiece onto the sample port.

2. Input information by a stylus pen.

NOTE: Maximum 24 characters for each input.

3. When displays "Ready, Please Blow", take a deep breath and blow until

BEEP tone stops.

4. A photo will be taken while the testee is blowing.

5. A passive test can be performed by pressing

blowing.

6. Test result displays on the display.

7. If testee did not blow within 30 seconds, tester can press

testee refused to do the test; or press

again.

8. If testee failed to give a valid breath sample, tester can press

or press

to allow testee to do the test again.

Following this procedure will

during the testee is

to allow testee to do the test

P. 5

to confirm the

to confirm;