Assembly
Tools needed: 6mm hex wrench (provided), 3mm hex wrench
(provided), #2 Phillips head screwdriver (not provided)
• WARNING: Unpack the Direct Supply Attendant Mobile
Sphygmomanometer in an area with sufficient room to
work. Do not allow residents near the device until it has
been completely set up and the work area has been cleared
of all debris. Inspect the device for damage. If the device is
damaged or the wrong device was accidentally sent, DO NOT
USE IT and immediately contact Direct Supply Equipment &
Furnishings for further instruction.
1. With base on its side connect upright outer sleeve to
the base using 6mm hex nut and lock washer as shown.
Tighten with the 6mm hex wrench. T ighten the hex nut
securely. Turn the base upright and insert the spring into
the upright sleeve. Then place the stainless steel tube into
the upright sleeve with the open end facing up.
2. L oosen the hex nut on the collar of the cuff storage basket
with the 3mm hex wrench provided. Place the cuff storage
basket atop the stainless steel tube. Make sure the tube
goes completely inside the collar and tighten the hex nut.
3. A ttach the plate to the manometer gauge using the small
Phillips head bolts (x2), matching washers (x2), and
matching nuts (x2).
4. Attach the manometer gauge assembly to the cuff storage
basket and secure with the large hex bolt (using the 6mm
hex wrench), washer, and nut.
5. Attach coiled tubing to air inlet of manometer gauge. Insert
"male" connector of coiled tubing into the "female" connector
on the bladder tubing. Fold cuff and store in the basket.
6. The height of the manometer gauge can be adjusted by
loosening the knob at the top of the black upright sleeve, moving
the tube to the desired height, and re-tightening the knob.
4
Stampa la pagina