Direct Supply Attendant Kullanıcı El Kitabı - Sayfa 4

Tıbbi Ekipman Direct Supply Attendant için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Direct Supply Attendant 12 sayfaları. Pen light
Ayrıca Direct Supply Attendant için: Kullanıcı El Kitabı (2 sayfalar), Kullanıcı El Kitabı (12 sayfalar), Kullanıcı El Kitabı (8 sayfalar), Kullanıcı El Kitabı (2 sayfalar), Kullanıcı El Kitabı (2 sayfalar), Kullanıcı El Kitabı (2 sayfalar), Kullanıcı El Kitabı (2 sayfalar)

Assembly

Tools needed: 6mm hex wrench (provided), 3mm hex wrench

(provided), #2 Phillips head screwdriver (not provided)

• WARNING: Unpack the Direct Supply Attendant Mobile

Sphygmomanometer in an area with sufficient room to

work. Do not allow residents near the device until it has

been completely set up and the work area has been cleared

of all debris. Inspect the device for damage. If the device is

damaged or the wrong device was accidentally sent, DO NOT

USE IT and immediately contact Direct Supply Equipment &

Furnishings for further instruction.

1. With base on its side connect upright outer sleeve to

the base using 6mm hex nut and lock washer as shown.

Tighten with the 6mm hex wrench. T ighten the hex nut

securely. Turn the base upright and insert the spring into

the upright sleeve. Then place the stainless steel tube into

the upright sleeve with the open end facing up.

2. L oosen the hex nut on the collar of the cuff storage basket

with the 3mm hex wrench provided. Place the cuff storage

basket atop the stainless steel tube. Make sure the tube

goes completely inside the collar and tighten the hex nut.

3. A ttach the plate to the manometer gauge using the small

Phillips head bolts (x2), matching washers (x2), and

matching nuts (x2).

4. Attach the manometer gauge assembly to the cuff storage

basket and secure with the large hex bolt (using the 6mm

hex wrench), washer, and nut.

5. Attach coiled tubing to air inlet of manometer gauge. Insert

"male" connector of coiled tubing into the "female" connector

on the bladder tubing. Fold cuff and store in the basket.

6. The height of the manometer gauge can be adjusted by

loosening the knob at the top of the black upright sleeve, moving

the tube to the desired height, and re-tightening the knob.