Zanussi ZOP37972BK Manuale d'uso - Pagina 22

Sfoglia online o scarica il pdf Manuale d'uso per Forno Zanussi ZOP37972BK. Zanussi ZOP37972BK 33.

Zanussi ZOP37972BK Manuale d'uso
STAINLESS STEEL OR ALUMINIUM OVENS
Clean the oven door with a damp cloth or sponge
only. Dry it with a soft cloth.
Do not use steel wool, acids or abrasive materials
as they can damage the oven surface. Clean the
oven control panel with the same precautions.
REMOVING THE SHELF SUPPORTS
To clean the oven, remove the shelf supports.
CAUTION! Be careful when you
remove the shelf supports.
1. Pull the front of the shelf support away from the
side wall.
2. Pull the rear end of the shelf support away from
the side wall and remove it.
1
Install the removed accessories in the opposite
sequence.
PYROLYSIS
CAUTION! Remove all accessories
and removable shelf supports.
Do not start the Pyrolysis if you did not
fully close the oven door. In some
models, the display shows "C3" when
this error occurs.
WARNING! The oven becomes very
hot. There is a risk of burns.
CAUTION! If there are other
appliances installed in the same
cabinet, do not use them when the
Pyrolysis function operates. It can
cause damage to the appliance.
1. Wipe out the cavity with a wet, soft cloth.
22
2
2. Clean the inner side of the door with hot water,
so that the residues do not burn from the hot
air.
3. Set the Pyrolysis function. Refer to "Daily use"
chapter, "Oven Functions".
4. When
flashes, press
pyrolysis duration:
Option
P1
P2
Press
or turn the knob for the temperature to
start the pyrolysis.
You can use the END function to delay the start of
the cleaning.
During the pyrolysis the oven lamp is off.
5. When the oven is at the set temperature, the
door locks. The display shows
of the heat indicator until the door unlocks.
To stop pyrolysis before it is completed, turn
the knob for the oven functions to the off
position.
6. When pyrolysis is completed, the display
shows the time of day. The oven door stays
locked.
7. When the oven is cool again, the door unlocks.
CLEANING REMINDER
To remind you that the pyrolysis is necessary, PYR
flashes in the display for 10 seconds after each
activation and deactivation of the oven.
The cleaning reminder goes out:
after the end of the pyrolysis.
if you press
time while PYR flashes in the
display.
REMOVING AND INSTALLING DOOR
The oven door has three glass panels. You can
remove the oven door and the internal glass panels
to clean them. Read the whole "Removing and
installing door" instruction before you remove the
glass panels.
or
to set the
Description
Light cleaning. Du-
ration: 1 h.
Normal cleaning.
Duration: 1 h 30
min.
and the bars
and
at the same