Zanussi ZOP37972BK 사용자 설명서 - 페이지 22

{카테고리_이름} Zanussi ZOP37972BK에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZOP37972BK 33 페이지.

페이지 인쇄

STAINLESS STEEL OR ALUMINIUM OVENS

Clean the oven door with a damp cloth or sponge

only. Dry it with a soft cloth.

Do not use steel wool, acids or abrasive materials

as they can damage the oven surface. Clean the

oven control panel with the same precautions.

REMOVING THE SHELF SUPPORTS

To clean the oven, remove the shelf supports.

CAUTION! Be careful when you

remove the shelf supports.

1. Pull the front of the shelf support away from the

side wall.

2. Pull the rear end of the shelf support away from

the side wall and remove it.

Install the removed accessories in the opposite

sequence.

PYROLYSIS

CAUTION! Remove all accessories

and removable shelf supports.

Do not start the Pyrolysis if you did not

fully close the oven door. In some

models, the display shows "C3" when

this error occurs.

WARNING! The oven becomes very

hot. There is a risk of burns.

CAUTION! If there are other

appliances installed in the same

cabinet, do not use them when the

Pyrolysis function operates. It can

cause damage to the appliance.

1. Wipe out the cavity with a wet, soft cloth.

2. Clean the inner side of the door with hot water,

so that the residues do not burn from the hot

air.

3. Set the Pyrolysis function. Refer to "Daily use"

chapter, "Oven Functions".

4. When

flashes, press

pyrolysis duration:

Option

Press

or turn the knob for the temperature to

start the pyrolysis.

You can use the END function to delay the start of

the cleaning.

During the pyrolysis the oven lamp is off.

5. When the oven is at the set temperature, the

door locks. The display shows

of the heat indicator until the door unlocks.

To stop pyrolysis before it is completed, turn

the knob for the oven functions to the off

position.

6. When pyrolysis is completed, the display

shows the time of day. The oven door stays

locked.

7. When the oven is cool again, the door unlocks.

CLEANING REMINDER

To remind you that the pyrolysis is necessary, PYR

flashes in the display for 10 seconds after each

activation and deactivation of the oven.

The cleaning reminder goes out:

•

after the end of the pyrolysis.

•

if you press

time while PYR flashes in the

display.

REMOVING AND INSTALLING DOOR

The oven door has three glass panels. You can

remove the oven door and the internal glass panels

to clean them. Read the whole "Removing and

installing door" instruction before you remove the

glass panels.

to set the

Description

Light cleaning. Du-

ration: 1 h.

Normal cleaning.

Duration: 1 h 30

min.

and the bars

and

at the same