Zanussi ADVANTAGE 106 Manuale d'uso - Pagina 23

Sfoglia online o scarica il pdf Manuale d'uso per Lavatrice Zanussi ADVANTAGE 106. Zanussi ADVANTAGE 106 27. Front-loading washing machine

4. The water inlet hose filter

If your water is very hard or contains traces of lime

deposit, the water inlet filter may become clogged.

It is therefore a good idea to clean it from time to

time.

Turn off the water tap. Unscrew the water inlet hose.

Clean the filter using a hard bristle brush.

Tighten up the inlet hose.

If the water is not discharged (outlet pump is

blocked, filter or drain hose are clogged), proceed as

follows to empty out the machine:

• pull out the plug from the power socket;

• close the water tap;

• if necessary, wait until the water has cooled down;

• open the drainage area door;

• place a bowl to collect the water;

• release the emergency emptying hose, place it in

the bowl and remove its cap, when the bowl is full

put the cap back on the emergency emptying hose;

• empty the bowl, repeat the procedure until you

have completely emptied the washing machine;

• replace the emergency emptying hose in its initial

position and close the drainage area door.

If the machine is installed in a place where the

temperature could drop below 0°C, proceed as

follows:

• disconnect the appliance;

• close the water tap;

• if necessary, wait until the water has cooled down;

• open the drainage area door;

• place a bowl to collect the water that will flow out;

• release the emergency emptying hose, place it in

the bowl and remove its cap;

• when the water stops flowing out, put the cap back

on the emergency emptying hose, replace the

emergency emptying hose in its initial position and

close the drainage area door.

By doing this, any water remaining in the machine is

removed, avoiding the formation of ice and,

consequently, breakage of the affected parts.

When you use the machine again, make sure that

the ambient temperature is above 0°C.