Zanussi DTI 4725 Libretto di istruzioni - Pagina 15

Sfoglia online o scarica il pdf Libretto di istruzioni per Lavastoviglie Zanussi DTI 4725. Zanussi DTI 4725 27. Dishwasher dti 4725

Stampa la pagina

Operating sequence

Check the filters

Ensure they are clean and properly

positioned (see cleaning instructions).

Check that there is rinse aid

and salt

Load the dishes

Remove any scraps of food.

Pull the lower basket out and arrange the

saucepans, plates and cutlery in it.

Pull the upper basket out and arrange the

plates, saucers, glasses and cups etc. in it.

Slide the basket back into the machine.

Ensure that the spray arms can

rotate freely.

Measure out detergent

Add the required amount of detergent into

the dispenser according to the Programme

chart and close the lid.

Close the detergent dispenser

lid

Set the programme

The selection of a programme occurs with

the door partially opened.

Depress the On/Off button; the On/Off

indicator light comes on.

Depress the programme button which

corresponds to the washing programme

you wish to select; the corresponding

indicator light will flash.

Start the programme

Close the dishwasher door. An audible

signal of about 1 second advises you that

the programme has started. The indicator

light which corresponds to the programme

under way is now permanently on.

At the end of the washing

programme

The dishwasher will automatically stop and

an intermittent audible signal of about 5

seconds informs you that the programme

has finished.

Wait until the end of the signal before

opening the door.

10. Switch off the dishwasher

Open the door.

The "End of cycle" indicator light flashes.

Depress the On/Off button to switch the

dishwasher off.

When the wash programme has

finished, it is recommended that the

dishwasher is unplugged and the water

tap turned off.

In general it is not advisable to open the

door while the machine is working;if the

door is opened however, a safety device

ensures that the machine stops.

Caution

Do not open the door during the hot

phase: this may cause hot water

escape.

Care must be taken if the door is

opened during the hot phase or

immediately after a programme has

finished, as steam may escape.

11. Cancel the wash programme

To change a wash programme

To change a wash programme in progress

depress the button corresponding to the

programme you wish to cancel for about 1

second, until the relevant control light

goes out. The dishwasher is now reset and

you can select a new programme.

POS02GB