Zanussi ZBF22451SA Manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale d'uso per Congelatore Zanussi ZBF22451SA. Zanussi ZBF22451SA 16.
Anche per Zanussi ZBF22451SA: Manuale d'uso (16 pagine), Manuale d'uso (17 pagine), Manuale d'uso (16 pagine), Manuale d'uso (45 pagine)

Stampa la pagina

Problem

The compressor does not

start immediately after

pressing the Fast Freeze

button, or after changing

the temperature.

Temperature cannot be set. Fast Freeze function is switched on.

The temperature in the ap-

pliance is too low/high.

Upper or lower square is

shown in the temperature

Display.

dEMO appears on the Dis-

play.

Replacing the lamp

The appliance is equipped with a longlife LED

interior light.

Only service is allowed to replace the lighting

device. Contact your Service Center .

Closing the door

1. Clean the door gaskets.

Care and cleaning

Caution! Unplug the appliance before

carrying out any maintenance operation.

This appliance contains hydrocarbons in its

cooling unit; maintenance and recharging

must therefore only be carried out by authorized

technicians.

Periodic cleaning

The equipment has to be cleaned regularly:

Possible cause

This is normal, no error has occur-

red.

The temperature regulator is not set

correctly.

The door is not closed correctly.

The product temperature is too

high.

Many products are stored at the

same time.

An error has occurred in measuring

the temperature.

The appliance is in demonstration

mode (dEMO).

The compressor starts after a period

of time.

Switch off Fast Freeze manually, or

wait to set the temperature until the

function has reset automatically. Re-

fer to "Fast Freeze function".

Set a higher/lower temperature.

Refer to "Closing the door".

Let the product temperature de-

crease to room temperature before

storage.

Store less products at the same time.

Call your service representative (the

cooling system will continue to keep

food products cold, but temperature

adjustment will not be possible.)

Keep pressed approximately 10 sec.

the OK button since a long sound of

buzzer is heard and the Display shut

off for a short while: appliance start

works regularly.

2. If necessary, adjust the door. Refer to "In-

stallation".

3. If necessary, replace the defective door

gaskets. Contact the Service Center.

• clean the inside and accessories with luke-

warm water and some neutral soap.

• regularly check the door seals and wipe clean

to ensure they are clean and free from debris.

• rinse and dry thoroughly.

Solution