Zanussi ZBF22451SA Руководство пользователя - Страница 8
Просмотреть онлайн или скачать pdf Руководство пользователя для Морозильная камера Zanussi ZBF22451SA. Zanussi ZBF22451SA 16 страниц.
Также для Zanussi ZBF22451SA: Руководство пользователя (16 страниц), Руководство пользователя (17 страниц), Руководство пользователя (16 страниц), Руководство пользователя (45 страниц)
Печатать страницу
Problem
The compressor does not
start immediately after
pressing the Fast Freeze
button, or after changing
the temperature.
Temperature cannot be set. Fast Freeze function is switched on.
The temperature in the ap-
pliance is too low/high.
Upper or lower square is
shown in the temperature
Display.
dEMO appears on the Dis-
play.
Replacing the lamp
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Service Center .
Closing the door
1. Clean the door gaskets.
Care and cleaning
Caution! Unplug the appliance before
carrying out any maintenance operation.
This appliance contains hydrocarbons in its
cooling unit; maintenance and recharging
must therefore only be carried out by authorized
technicians.
Periodic cleaning
The equipment has to be cleaned regularly:
8
Possible cause
This is normal, no error has occur-
red.
The temperature regulator is not set
correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
An error has occurred in measuring
the temperature.
The appliance is in demonstration
mode (dEMO).
The compressor starts after a period
of time.
Switch off Fast Freeze manually, or
wait to set the temperature until the
function has reset automatically. Re-
fer to "Fast Freeze function".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature before
storage.
Store less products at the same time.
Call your service representative (the
cooling system will continue to keep
food products cold, but temperature
adjustment will not be possible.)
Keep pressed approximately 10 sec.
the OK button since a long sound of
buzzer is heard and the Display shut
off for a short while: appliance start
works regularly.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
• clean the inside and accessories with luke-
warm water and some neutral soap.
• regularly check the door seals and wipe clean
to ensure they are clean and free from debris.
• rinse and dry thoroughly.
Solution
www.zanussi.com