Zanussi 7332543286072 Manuale d'uso - Pagina 16

Sfoglia online o scarica il pdf Manuale d'uso per Fornelli Zanussi 7332543286072. Zanussi 7332543286072 24.
Anche per Zanussi 7332543286072: Manuale d'uso (24 pagine), Manuale d'uso (20 pagine), Manuale d'uso (20 pagine), Manuale d'uso (24 pagine)

Stampa la pagina

5. Clean the glass panel with water and soap.

Dry the glass panel carefully.

When the cleaning is complete, install the glass

panels and the oven door. Do the above steps

in the opposite sequence. Install the smaller

panel first, then the larger.

CAUTION!

The screen with a printing on the

inner glass panel must face the inner

side of the door.

CAUTION!

Make sure that after installation the

surface of the frame of the glass

panel on the screen with a printing is

not rough when you touch it.

CAUTION!

Make sure that you install the

internal glass panel in the

appropriate seats.

Replacing the lamp

Put a cloth on the bottom of the interior of the

appliance. It prevents damage to the lamp glass

cover and the cavity.

Troubleshooting

WARNING!

Refer to Safety chapters.

What to do if...

Problem

You cannot activate the appli-

ance.

You cannot activate or operate

the hob.

The oven does not heat up.

The oven / hob display shows an

error code that is not in this ta-

ble.

1. Deactivate the appliance.

2. Remove the fuses from the fuse box or

The back lamp

1. Turn the lamp glass cover counterclockwise

2. Clean the glass cover.

3. Replace the lamp with a halogen, 230 V, 40

4. Install the glass cover.

Possible cause

The appliance is not connected

to an electrical supply or it is

connected incorrectly.

The fuse is blown.

There is an electrical fault.

WARNING!

Danger of electrocution! Disconnect

the fuse before you replace the

lamp.

The lamp and the lamp glass cover

can be hot.

deactivate the circuit breaker.

to remove it.

W, 300 °C heat resistant lamp.

Check if the appliance is correct-

ly connected to the electrical

supply.

Make sure that the fuse is the

cause of the malfunction. If the

fuse is blown again and again,

contact a qualified electrician.

Deactivate the appliance with the

house fuse or the safety switch in

the fuse box and activate it again.

If the display shows the error

code again, contact the Custom-

er Care Department.

Remedy