Zanussi 7332543286072 Gebruikershandleiding - Pagina 16
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Zanussi 7332543286072. Zanussi 7332543286072 24 pagina's.
Ook voor Zanussi 7332543286072: Gebruikershandleiding (24 pagina's), Gebruikershandleiding (20 pagina's), Gebruikershandleiding (20 pagina's), Gebruikershandleiding (24 pagina's)
Pagina afdrukken
5. Clean the glass panel with water and soap.
Dry the glass panel carefully.
When the cleaning is complete, install the glass
panels and the oven door. Do the above steps
in the opposite sequence. Install the smaller
panel first, then the larger.
CAUTION!
The screen with a printing on the
inner glass panel must face the inner
side of the door.
CAUTION!
Make sure that after installation the
surface of the frame of the glass
panel on the screen with a printing is
not rough when you touch it.
CAUTION!
Make sure that you install the
internal glass panel in the
appropriate seats.
Replacing the lamp
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
Troubleshooting
WARNING!
Refer to Safety chapters.
What to do if...
Problem
You cannot activate the appli-
ance.
You cannot activate or operate
the hob.
The oven does not heat up.
The oven / hob display shows an
error code that is not in this ta-
ble.
16
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
The back lamp
1. Turn the lamp glass cover counterclockwise
2. Clean the glass cover.
3. Replace the lamp with a halogen, 230 V, 40
4. Install the glass cover.
Possible cause
The appliance is not connected
to an electrical supply or it is
connected incorrectly.
The fuse is blown.
There is an electrical fault.
WARNING!
Danger of electrocution! Disconnect
the fuse before you replace the
lamp.
The lamp and the lamp glass cover
can be hot.
deactivate the circuit breaker.
to remove it.
W, 300 °C heat resistant lamp.
Check if the appliance is correct-
ly connected to the electrical
supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Deactivate the appliance with the
house fuse or the safety switch in
the fuse box and activate it again.
If the display shows the error
code again, contact the Custom-
er Care Department.
Remedy
www.zanussi.com