Directed XpressKit DBALL Manuale - Pagina 9

Sfoglia online o scarica il pdf Manuale per Per serrature Directed XpressKit DBALL. Directed XpressKit DBALL 14. Ford5 remote start ready (rsr) installation
Anche per Directed XpressKit DBALL: Manuale di installazione (16 pagine), Manuale di installazione (16 pagine), Manuale (19 pagine)

Stampa la pagina

Platform: DBALL/DBALL2

Firmware: FORD5 Range Extender Ready (RXT) Installation

LED Diagnostics & Troubleshooting

LED

Description

Programming the Module

Off

Module has no power.

Waiting to begin the

Solid red

programming sequence.

CAN was detected.

Flashes green

Bypass is waiting for the

Solid orange

ignition startup.

Bypass was skipped.

Flashes orange

Module was successfully

Solid green

x 3 secs

programmed.

Module was successfully

Solid orange

x 3 secs

programmed without bypass.

Module Programming - Error Codes

Flashes red

CAN2 was not detected.

x 2

Flashes red

Bypass data was not detected.

x 3

Flashes red

Bypass processing error.

x 4

External Module Synchronisation

Flashes red,

OBDII feature is not supported.

red, then

orange x 10

Active Ground While Running

GROUND OUT ON (GWR)

Flashes green

command received.

D2D and W2W Commands

Flashes orange

Lock command received.

x 1

Flashes orange

Unlock command received.

x 2

Trunk release command

Flashes orange

x 3

received.

Troubleshooting

Make sure that 14-pin (blue) plug is connected and that 12 Volt is

present between the red and black wires. If the 12 Volt connection is

present, the module may be defective.

Make sure that all the connections are correct. See wiring diagram.

Normal operation.

Normal operation. Immobilizer bypass programming was skipped.

Normal operation.

Normal operation. Immobilizer bypass programming was skipped.

Check the Tan - Tan/Black wire connections. Wake up the data bus

by turning the ignition on and try again.

Check the bypass line connection. If more than one wire is used,

make sure they are not inverted. Start vehicle using the key to

confirm the OEM equipment is still operational.

Bypass calculation failed. Reset the module and try again.

Diagnostic data bus was not detected. Some features are not

supported by SmartStart. This can be caused by missing wire

connections or module hardware limitation. Refer to "Installation

(wiring diagrams & vehicle wiring reference charts)" to check the

connections.

Otherwise, the Ground While Running (status) signal was lost or was

never received by the module.

If the bypass module fails to flash, it means the module did not

receive the signal. Verify the connections between the bypass and

the remote starter module.

Go to the next page to see the rest of the LED Diagnostics & Troubleshooting.

Rev.: 20160317

Page 9