Directed Xpresskit DBALL2 Manuale di installazione - Pagina 5

Sfoglia online o scarica il pdf Manuale di installazione per Per serrature Directed Xpresskit DBALL2. Directed Xpresskit DBALL2 12. Ford5 remote start ready (rsr) installation
Anche per Directed Xpresskit DBALL2: Manuale di installazione (19 pagine), Manuale di installazione (18 pagine), Manuale (14 pagine), Manuale di installazione (13 pagine), Manuale di installazione (14 pagine), Manuale di installazione (19 pagine), Manuale di installazione (16 pagine), Manuale di installazione (20 pagine), Manuale di installazione (15 pagine), Manuale di installazione e di consultazione rapida (16 pagine), Manuale di installazione (18 pagine), Manuale di installazione (16 pagine), Manuale di installazione (18 pagine), Manuale di installazione (16 pagine), Manuale (19 pagine)

Stampa la pagina
Directed Xpresskit DBALL2 Manuale di installazione
Platform: DBALL2
Firmware: MIT2

Module Programming

Refer to the LED Diagnostics section on pages 8-9 for more information and for troubleshooting purposes.
Important
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
Warning!
To take advantage of advanced features, you must use XpressVIP 4.5 or higher. Using version 2.9 or 3.1 will limit
available functions and features.
1. Connect the interface module to your computer using the XKLoader.
2. Open an Internet Explorer browser (version 6 or higher), and go to www.directechs.com. The detail of the platform and firmware
that is currently saved on the interface module will be indicated in the top left corner of the page.
3. Select the year, make and model of the vehicle; the page will refresh to display the compatible firmware.
4. In the search result page, select Flash Standard install, and follow the instructions provided on the screen.
5. Once you have configured your options, click on the FLASH button to upload the firmware onto the interface module.
6. The following message will be displayed when the upload is completed:
"The flashing is successfully completed. You may now unplug the kit."
You can now proceed with the programming instructions below.
D2D Installation
If required for your installation, connect the 10-pin, 12-pin and 14-pin harnesses to
the module, then connect the 4-pin D2D harness.
OR
W2W Installation
If required for your installation, connect the 10-pin and 12-pin harnesses to the
module, then connect the 14-pin harness to the module.
1
Wait until the LED turns ON solid red.
Press the Push-to-Start button twice to turn ignition ON.
The LED flashes green.
2
The LED turns ON solid green for 3 seconds, then turns
OFF once the module has been successfully programmed.
3
Press the Push-to-Start button one more time to turn ignition OFF.
You have successfully completed the module programming sequence.
th
4
st
1
st
1
&
ENGINE
PUSH
START
STOP
Press 2x
Flashes
© 2017 Directed. All rights reserved.
Rev.: 20170620
Page 5
rd
3
nd
2
rd
3
nd
2
Solid
&
&
Solid
Off
x3 secs
ENGINE
PUSH
START
STOP
Press 1x