Directed Xpresskit DBALL2 설치 매뉴얼 - 페이지 5

{카테고리_이름} Directed Xpresskit DBALL2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Xpresskit DBALL2 12 페이지. Ford5 remote start ready (rsr) installation
Directed Xpresskit DBALL2에 대해서도 마찬가지입니다: 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (18 페이지), 매뉴얼 (14 페이지), 설치 매뉴얼 (13 페이지), 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (15 페이지), 설치 및 빠른 참조 매뉴얼 (16 페이지), 설치 매뉴얼 (18 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (18 페이지), 설치 매뉴얼 (16 페이지), 매뉴얼 (19 페이지)

페이지 인쇄

Platform: DBALL2

Firmware: MIT2

Module Programming

Refer to the LED Diagnostics section on pages 8-9 for more information and for troubleshooting purposes.

Important

Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to

ensure everything is correct prior to moving onto the next step.

Warning!

To take advantage of advanced features, you must use XpressVIP 4.5 or higher. Using version 2.9 or 3.1 will limit

available functions and features.

1. Connect the interface module to your computer using the XKLoader.

2. Open an Internet Explorer browser (version 6 or higher), and go to www.directechs.com. The detail of the platform and firmware

that is currently saved on the interface module will be indicated in the top left corner of the page.

3. Select the year, make and model of the vehicle; the page will refresh to display the compatible firmware.

4. In the search result page, select Flash Standard install, and follow the instructions provided on the screen.

5. Once you have configured your options, click on the FLASH button to upload the firmware onto the interface module.

6. The following message will be displayed when the upload is completed:

"The flashing is successfully completed. You may now unplug the kit."

You can now proceed with the programming instructions below.

D2D Installation

If required for your installation, connect the 10-pin, 12-pin and 14-pin harnesses to

the module, then connect the 4-pin D2D harness.

W2W Installation

If required for your installation, connect the 10-pin and 12-pin harnesses to the

module, then connect the 14-pin harness to the module.

Wait until the LED turns ON solid red.

Press the Push-to-Start button twice to turn ignition ON.

The LED flashes green.

The LED turns ON solid green for 3 seconds, then turns

OFF once the module has been successfully programmed.

Press the Push-to-Start button one more time to turn ignition OFF.

You have successfully completed the module programming sequence.

ENGINE

PUSH

START

STOP

Press 2x

Flashes

Rev.: 20170620

Page 5

Solid

Off

x3 secs

ENGINE

PUSH

START

STOP

Press 1x