Directed Xpresskit DBALL2 설치 매뉴얼 - 페이지 3

{카테고리_이름} Directed Xpresskit DBALL2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Xpresskit DBALL2 12 페이지. Ford5 remote start ready (rsr) installation
Directed Xpresskit DBALL2에 대해서도 마찬가지입니다: 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (18 페이지), 매뉴얼 (14 페이지), 설치 매뉴얼 (13 페이지), 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (15 페이지), 설치 및 빠른 참조 매뉴얼 (16 페이지), 설치 매뉴얼 (18 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (18 페이지), 설치 매뉴얼 (16 페이지), 매뉴얼 (19 페이지)

페이지 인쇄
Directed Xpresskit DBALL2 설치 매뉴얼
Platform: DBALL2
Firmware: MIT2
Wiring Diagram
6 Amp
diodes
(+) Parking
Lights (left):
White/Black,
1 2
pin 6
6
(-) PTS 1:
(+) PTS 2:
Yellow, pin 2
Lt. Green/Red, pin 4
1
2
3
4
5
6
7
8
9
10
Not required in D2D mode.
Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
[1]
Connect Lock wire only if ignition controlled locks feature is active. This feature is configurable in your remote starter.
[2]
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.
C-417
(white conn. at
fusebox in driver dash)
(-) Hood Status Input
(+) Brake Status Input
(AC) Tach Input
[1]
(-) Trunk Status Input
(-) Door Status Input
(-) E-Brake Status Input
(+) Parking Lights Output
(+) Ignition Output
(+) Parking
Lights
(right):
Black/
(+) Ignition:
White, pin 3
Brown/Red,
pin 2
3
4
5
2
7
8
9
10
11
12 13
1
4
5
6
7
C-418
(white conn.at fusebox
C-402
in driver dash)
(white conn. at
fusebox in driver dash)
HS CAN High: Yellow, pin 6
1
9
HS CAN Low: Brown, pin 14
HS CAN 1 High: Tan/Black: 3
HS CAN 1 Low: Tan: 4
HS CAN 2 High: Orange/Green: 5
HS CAN 2 Low: Orange/Brown: 6
(+) 12V
(+) 12V: Red: 13
(-) Ground
(-) Ground: Black: 14
(-) E-Brake Status Output: Black/White: 1
(-) PTS 1 Output: Green/Black: 2
(-) Door Status Output: Green/White: 3
(-) Trunk Status Output: Red/Black: 4
(AC) Tach Output: Violet/White: 5
[1]
(+) Brake Status Output: Gray: 6
(+) PTS 2 Output: Violet/Brown: 9
(-) Hood Status Output: Blue/Red: 12
Engine Start/Stop Switch
(white conn. at PTS button)
HS CAN 2 Low: Red/White, pin 16
HS CAN 1 High: Yellow/Pink, pin 17
36
35
34
33
32
31
30
29
28
27
26
25
24
15
14
13
12
11
10
9
8
[2] (-) Lock: Gray, pin 28
(-) Lock Output
(-) Unlock Output
(-) GWR (Status)
(+) Starter Output
(-) Ground
(+) 12V
(+) 12V:
White, pin 2
3
C-410
(black conn. at
8
fusebox in driver dash)
Diagnostic connector
8
OBDII
(connector side view)
16
RF
DBALL2
Prog. Button
LED
Use only for Ignition
23
22
21
20
19
18
17
16
controlled locks feature
7
6
5
4
3
2
1
(+) Starter: Violet, pin 9
1 2
3
9
6
7
8
10
11
C-420
(white conn. at fusebox in driver dash)
C-418
C-417
10: Blue/White: (-) GWR (Status) Input
2: Blue: (-) Unlock Input
1: Green: (-) Lock Input
(+)12V
RX
(-) Ground
TX
P#: XKD2D65
© 2017 Directed. All rights reserved.
Rev.: 20170620
Page 3
.
[2]
4
5
12 13