Clarke Woodworker CDS300 Manuale d'uso e manutenzione - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso e manutenzione per Sander Clarke Woodworker CDS300. Clarke Woodworker CDS300 12. 300mm disc sander

Fig.1

For greater accuracy, the mitre gauge is used so that the work may be held at a

required angle and moved across the disc as shown in Figs. 1 and 2.

Use a slight pressure ONLY... let the disc do the work. Pressure should be on the

DOWNWARDS direction of motion of the disc ONLY. i.e. on the left half of the disc

as shown in Figs.1 and 2.

NOTE:

Replacement sanding discs (packets of 5) in three different grit sizes are available

from your Clarke dealer. (See Accessories below).

We STRONGLY recommend that a dust extraction device is used with this machine.

Simply attach a suitable hose from the dust extractor to the outlet, beneath the

table. A vacuum cleaner may be used for this purpose if a purpose built dust

extractor is not available. (Dust extractors are available from your Clarke dealer).

MAINTENANCE

ALWAYS disconnect the machine from the mains supply BEFORE performing any

maintenance operation.

The machine is completely maintenance free, with the exception of ensuring it is

kept clean and free from build up of sawdust at all times. This should be carried

out with an old paintbrush or similar, and a vacuum cleaner.

The panel beneath the table is secured by two screws. Remove these to gain

access to the lower half of the disc.

ACCESSORIES

Sanding Discs, self adhesive (Packets of 5)

60 Grit ................................................... Part No. 6502305

80 Grit ................................................... Part No. 6502310

120 Grit ................................................. Part No. 6502315

Fig.2