Clarke Woodworker CS6-9C Manuale d'uso e manutenzione - Pagina 12
Sfoglia online o scarica il pdf Manuale d'uso e manutenzione per Sander Clarke Woodworker CS6-9C. Clarke Woodworker CS6-9C 15. Belt & disc sander belt & disc sander
Stampa la pagina
MAINTENANCE
CAUTION: Before carrying out any maintenance or servicing, ALWAYS ensure the
plug is disconnected from the mains supply.
A. Changing the Belt
1. Raise the table and secure in the vertical position.
2. Remove the lower Belt Cover, by
slackening the four securing screws
sufficiently for the cover to be
slipped off.
3. Remove the screw securing the dust
hand (or rear) mounting.
4. Slide the Belt Tension Lever fully
FORWARD. (As the Belt Arm is vertical,
this would be - UPWARDS).
The belt may now be slipped off and
replaced by a new one.
5. Tension the belt by sliding the tensioning lever backwards (downwards), then replace
the belt cover.
6. Proceed to check belt tracking, as described on page 7
B. Changing the Disc
1
Remove the disc side cover as shown
in Fig. 12, then peel off the disc.
2. Clean any excess adhesive from the
face of the disc, if any, and replace
with a new disc, ensuring it is firmly
attached.
3. When satisfied, replace cover.
- 12 -
Fig. 11
Fig. 12
Fig. 12A