Clarke Woodworker CS6-9C Operating & Maintenance Manual - Page 12

Browse online or download pdf Operating & Maintenance Manual for Sander Clarke Woodworker CS6-9C. Clarke Woodworker CS6-9C 15 pages. Belt & disc sander belt & disc sander

Print Page

MAINTENANCE

CAUTION: Before carrying out any maintenance or servicing, ALWAYS ensure the

plug is disconnected from the mains supply.

A. Changing the Belt

1. Raise the table and secure in the vertical position.

2. Remove the lower Belt Cover, by

slackening the four securing screws

sufficiently for the cover to be

slipped off.

3. Remove the screw securing the dust

hand (or rear) mounting.

4. Slide the Belt Tension Lever fully

FORWARD. (As the Belt Arm is vertical,

this would be - UPWARDS).

The belt may now be slipped off and

replaced by a new one.

5. Tension the belt by sliding the tensioning lever backwards (downwards), then replace

the belt cover.

6. Proceed to check belt tracking, as described on page 7

B. Changing the Disc

Remove the disc side cover as shown

in Fig. 12, then peel off the disc.

2. Clean any excess adhesive from the

face of the disc, if any, and replace

with a new disc, ensuring it is firmly

attached.

3. When satisfied, replace cover.

- 12 -

Fig. 11

Fig. 12

Fig. 12A