Alemite 8700 Manuale di servizio - Pagina 7
Sfoglia online o scarica il pdf Manuale di servizio per Pompa dell'acqua Alemite 8700. Alemite 8700 9. High-pressure hydraulic pump
Stampa la pagina
High-Pressure Hydraulic Pump
Refer to Figure 2 Parts List
for Parts Identification
Figure 5 Pump Tubes 337384-A1, B1, and G1 - Section View
Alemite LLC
12. Screw the Coupling assembly onto the
hydraulic motor rod until the pin holes
align.
• Install Pin (6).
Pump Tube (Outer Components)
13. Install and seat Seal (19) [lips first]
into the bottom of Retainer (18). See
Figure 2.
14. Install and seat Bearing (20) into the
bottom of the Retainer.
15. Install Gasket (21) onto the top of
Extension (22).
IMPORTANT: If a primer is used
with Loctite 222, the curing time
is greatly reduced.
16. Screw the Extension [with Loctite 222]
(Gasket end first) into the bottom of
the Retainer.
• Follow the thread sealant
manufacturer's recommendations.
•Do not tighten at this time.
17. Install Gasket (4) into the top of the
Retainer.
18. Install and seat Bearing (17) [small
diameter first] and additional Gasket
(4) into the top of the Retainer.
19. Screw Tube (16) [with Loctite 222]
into the top of the Retainer.
• Do not tighten at this time.
20. Install and seat Gasket (4) into Adapter
(3).
21. Screw the Tube assembly [with Loctite
222] into the Adapter.
• Do not tighten at this time.
22. Install O-Ring (2) onto the Adapter.
23. Apply grease to Piston (15).
• This will aid the installation process.
Install the outer component assembly
onto the inner assembly with care. Dam-
age to Seal (19) can occur.
7
SER 8700
CAUTION
Revision (2-13)