Clarke HSEC650A Istruzioni per il funzionamento e la manutenzione - Pagina 4
Sfoglia online o scarica il pdf Istruzioni per il funzionamento e la manutenzione per Pompa dell'acqua Clarke HSEC650A. Clarke HSEC650A 20. Submersible pumps
Anche per Clarke HSEC650A: Manuale di istruzioni per il funzionamento e la manutenzione (17 pagine)
Stampa la pagina
PUMP SAFETY INSTRUCTIONS
1. Only use the pump in the manner and for the functions described in these
instructions.
2. These pumps are designed to pump water only. Never use for pumping
flammable liquids or corrosive chemicals of any kind.
3. Never allow the pump to run dry. Switch the pump OFF immediately the
task is completed.
4. An approved Residual Current Device (RCD) must be used when pumping
from ponds or swimming pools.
5. The submersible pump may only be used for pumping water from a
swimming pool when there is no person or animal in the pool.
6. Do not attempt to carry out any repairs on the pump until it is unplugged
from the power supply.
7. Always lift the pump using the handle with rope or chain attached if
necessary. Never lift or carry the pump by the power cable or by the float
switch cable.
8. Always disconnect the pump from the electrical supply before placing it
into, or removing from the water, and before any cleaning or
maintenance of the pump.
9. Remember, the operator or user is responsible for accidents or hazards
occurring to other people or their property.
10. Do not install the pump on sand, silt or mud which is likely to shift or
collapse.
11. If the electrical cable becomes damaged, it must be replaced, - not
repaired.
12. Keep the work area well lit. Dark areas invite accidents.
13. Do not over-reach. Keep your proper footing and balance at all times
when handling the pump in waterlogged areas.
14. Store the pump out of the reach of children and do not allow persons
unfamiliar with these instructions to operate the pump.
15. Do not abuse the electrical cable. Never use the cable for pulling or
unplugging the pump Damaged or tangled cables increase the risk of
electric shock.
16. Check the pump for damage before use. Any damaged part should be
inspected to ensure that it will operate properly and perform its intended
function. Any damage should be properly repaired or the part replaced.
If in doubt, DO NOT use the appliance. Consult your local dealer.
17. When operating outdoors, use an extension cable suitable for outdoor
use. Using the correct cable reduces the risk of electric shock.
4