LEGO 42031 Manuale di avvio rapido

Sfoglia online o scarica il pdf Manuale di avvio rapido per Giocattolo LEGO 42031. LEGO 42031 8. Tow truck

42031 Tow Truck

Welcome to text-based instructions from LEGO for the Blind. Before you start building, here are some

terms we'll be using:

Front: towards you.

Back: away from you.

Up: towards the ceiling.

Down: towards the floor.

Stud: the bump on a Lego brick. Example: A 2x1 brick has two studs on it.

Vertically: going from front to back.

Horizontally: going from left to right.

Upright: pointing up towards the ceiling, and down towards the floor.

Symmetrically: a mirror image. Example: If you place a 2x1 brick with technic connector on the

front wall at the right, connector to the front, and then place another such piece symmetrically on

the back wall, at the right, the technic connector of the second piece should point to the back,

since it will be placed symmetrically.

There are also abbreviations defined at the end of this file.

Reach dizzying heights with the awesome LEGO® Technic Tow Truck! Let's get to work!

Tow truck

Bag 1.

Put a 9x1 oblong piece hor on the table, holes to front and back.

Insert a long connector from the front, short end first, into the leftmost hole.

Skip two holes to the right and repeat.

Bag 2.

Insert a rotating long connector from the back, short end first, into the second hole from the left.

Skip two holes to the right (including the one with the connector in) and insert a connector from the back.

Skip three holes to the right and insert a rotating long connector from the back, short end first.

Lay momentarily aside.

Bag 3.

Put a 13x1 oblong piece hor on the table, holes to front and back.

Insert a long connector from the front, short end first, into the 5th hole from the left.

Skip seven holes to the right and repeat (the rightmost hole).

Insert a long Philips connector from the front, short end first, into the 7th hole.

Hold a 2x1 oblong piece ver, upright, the holes to the front and back, the cross-hole on top, and put it

(with the cross-hole) from the front onto the middle (Philips) connector all the way.

Connect this part to your main structure by turning your oblong piece, so that the free hole faces down.