Clarke CHT403 Manuale di istruzioni per l'uso - Pagina 5
Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Strumenti Clarke CHT403. Clarke CHT403 8. Carpet knee kicker
The length of the kicker can be adjusted to best suit the user's preference
and working space.
The teeth can be set to protrude to a depth to best suit the thickness of the
carpet to be fitted.
The protection cover should always be fitted when the kicker is not in use and
should be left in place whilst adjusting the kickers' length. The teeth must be
retracted (setting 0) for the cover to be fitted. Keep the cover handy for re-
use during the job.
To remove the cover, grip it and pull it away from the kicker head.
LENGTH ADJUSTMENT
The telescopic steel tube is locked by means of
spring pins. The captive pins lock the tubes in
position through holes in the tubes. There are
two locking pins. These allow the kicker to be
adjusted in length from 470 mm to 545 mm (18½
to 21½ inches).
To adjust the length:
1. Press the two pins inwards and hold them in
this position whilst rotating one tube so the
pins are out of alignment so they remain
depressed.
2. Adjust to the required length by moving the
ends of the kicker closer together or further
apart, as required, then rotate the tubes
until the holes and pins are realigned. The
pins will spring out and lock the tubes in position.
TEETH DEPTH ADJUSTMENT
The teeth depth may be adjusted by means of the rotary depth control knob.
There are eight settings, 0 to 7. The lowest setting is '0' for thin pile carpets. The
maximum setting is '7' for deep pile carpets.
Determine the teeth depth required for the carpet
to be laid.
To do this, test on an off-cut of carpet to ensure
teeth depth selection is correct.
The teeth should be adjusted to grip the base
material of the carpet and not to pierce it, as this
could damage the underlay.
Rotate the adjuster knob to raise or lower the
teeth.
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
5